sys vim-speed

Configure all of the ports on an installed Versatile Interface Module (VIM) to operate at the same speed.

Note

This command is not supported on all VIMs. Some VIMs must operate with all ports at the same speed, or with a group of ports at the same speed, while others can operate with ports at different speeds. For more information, see Fabric Engine Release Notes.

Syntax

default sys vim-speed
sys vim-speed {1000 | 10000 | 25000 | auto}

Command Parameters

{1000 | 10000 | 25000 | auto}: Configures all VIM ports to operate at either 1 Gbps, 10 Gbps, 25 Gbps, or auto.

It is a best practice not to use a mix of 10Gbps and 25Gbps VIMs with the auto parameter.

Default

The default is 25 Gbps.

Command Mode

Global Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine User Guide.

The command auto vim-speed is enabled by default.

1 Gbps port speed is supported on 5720-VIM-6YE only.

If 5720-VIM-6YE uses the LRM/MACsec Adapter, you must configure the groups according to the SFP or SFP+ inserted in the Adapter.